My Beckett AFG..The below pictures are were taken after 5 days of running my home burner, after changing the head to a F3 and further downsizing the nozzle to a .75gph @140 psi.
Does it look like I misaligned the nozzle assembly somewhat when I changed the head? I just checked this mess with the Beckett T501 gauge as it seems to be back a hair, not more.
Look at the crap on the nozzle too.
The oil pump has the Honeywell silver solenoid on it.
Any ideas? Could the nozzle be defective, or just my inexperience.
On the other hand, even with our latest windy -2° low temperature and day time high of 6° cold spell, the heater/boiler kept the home warm, just as warm as the 1.25gph nozzle I replaced, and quite a bit quieter. Burner still was not running more than 68% to maintain our warm home, after the night time setback was terminated and interior temperature stabilized.
Thank you
Does it look like I misaligned the nozzle assembly somewhat when I changed the head? I just checked this mess with the Beckett T501 gauge as it seems to be back a hair, not more.
Look at the crap on the nozzle too.
The oil pump has the Honeywell silver solenoid on it.
Any ideas? Could the nozzle be defective, or just my inexperience.
On the other hand, even with our latest windy -2° low temperature and day time high of 6° cold spell, the heater/boiler kept the home warm, just as warm as the 1.25gph nozzle I replaced, and quite a bit quieter. Burner still was not running more than 68% to maintain our warm home, after the night time setback was terminated and interior temperature stabilized.
Thank you